Resources · Water

Acreage guides for towns in this county: Drumheller

How Deep Is the Water Table in Starland County?

Buyers ask this before they bid, and drillers ask it before they quote. In Starland County, nearby well records point to an average completed well depth of about 45 m, with static water levels often in the 14–26 m range. The predominant aquifer on file for this part of Alberta is the Horseshoe Canyon Formation sandstone.

Those numbers are county-scale context. They are not a promise for the quarter you are walking. These figures come from a Land Intelligence report run on a representative quarter in the county (NW 34-30-19-W4; 47 provincial well records within 5 km), not from your parcel.

Starland sits atop the Drumheller badlands, and wells here are deep by Alberta standards. Horseshoe Canyon sandstone is the usual target; low yields and high sodium are common enough that many farms haul or pipeline water.

What a “water table” number actually is in Starland County

Around Drumheller and the rest of Starland County, people use “water table” for three different things:

• Static water level — the resting height of water in a completed well, measured from ground surface.
• Completion depth — how far the driller had to go to find a usable interval.
• Seasonal high water — how close water sits to the surface in a wet year, which matters for basements, septic, and dugouts.

A listing that says “good water at 80 feet” is usually mixing those ideas. Eighty feet of steel is a completion depth. The pump may still hang much shallower if the static level is high. Or the well may be deep and the static level may still sit far down the hole in late summer.

In Starland County, treat 45 m as a planning band for completion, and 14–26 m as a planning band for static level. If a seller’s story sits far outside both bands, ask for the well ID and the last pump test.

What this means before you drill in Starland County

Budget three line items on a Starland County acreage, not one:

• Drilling and casing to a depth that can overshoot the neighbour’s well. In this county, planning around 45 m plus a contingency is more honest than copying the shallowest well on the road.
• A pump test, not a “we hit water” photo. Yield, drawdown, and recovery decide whether the well is a household supply.
• Water chemistry. Iron, hardness, sulphur, and bacteria are independent of depth. A cheap shallow well can still need treatment.

The Horseshoe Canyon Formation sandstone is common in this part of the province, but contacts shift. A buried-valley sand and a bedrock sandstone can sit under adjacent quarters. That is why a free parcel report that plots nearby well records is worth more than a single county average.

Flood and surface water are a separate file. In Starland County, notable mapped or commonly discussed hazard areas include Red Deer River valley and badlands, Michichi Creek, Rowley area coulees. A wet corner of a field is not automatically a well. It may be a wetland, a flood fringe, or both.

Reading a well record in Starland County

Alberta well reports usually list location, date, lithology, completion interval, static level, and a test rate. When you pull neighbours near Drumheller:

• Prefer wells within a kilometre, then compare geology, not just depth.
• Ignore abandoned holes unless you want to know where not to drill.
• Note the year. A 1978 farm well and a 2019 domestic well are not the same construction standard.
• If three nearby wells finish near 45 m and one is 15 m, ask why. The shallow one may be a sand point, a dugout well, or a different aquifer.

Permits, setbacks, and the rest of the Starland County water file

A new well in Starland County is only one approval. Earthworks for a pond, a dugout, or a crossing can trigger the Water Act. Mapped wetlands near Drumheller and across Starland County are common enough that you should not assume a “just a slough” story. Keep well planning and wetland planning in two piles so a good aquifer does not talk you into filling a regulated wetland.

See this for your specific parcel

County averages help you decide whether a listing is in the right universe. They cannot replace a pin on the map.

Generate a free land report for a property in Starland County →

The report is built to show water context, nearby records where available, and the other pillars — terrain, wetlands, climate, vegetation — on the same parcel.

Sampled data for Starland County

From a Land Intelligence report run on a representative quarter in Township 30, Range 19, W4. These are measured or record-based values for that location, shown to put the county figures above in context. They are not your parcel.

Neighbouring counties: Kneehill County (50 km) · Wheatland County (65 km) · County of Stettler (78 km) · Special Areas (2, 3 and 4) (90 km) · Compare Starland County with another county

Sampled from the live report pipeline at a representative quarter in Township 30, Range 19, W4 on 2026-10-08: well depth, hardiness zone, solar irradiance (47 well records within 5 km). Text reviewed 2026-10-09. Methodology.

Common questions

Is Starland County a good place to drill a well?

Many rural parcels in Starland County use private wells. Whether yours is “good” depends on the aquifer interval, chemistry, and a pump test — not the county average.

Can I use the neighbour’s well depth in Starland County?

Only as a hint. Geology can change between quarters. Pull the well ID and lithology before you copy a depth into a budget.